QUALITY PRODUCTS USED BY PROFESSIONALS


  

Wetblast FLEX

Wetblast FLEXTM All-In-One Wetblast System

Our all-in-one WETBLAST FLEXTM system gives you convenience you don’t get from traditional slurry systems. Its design and simplified set up and operation make for easier end-of-shift shutdown. By mixing the abrasive and water after it leaves the blast machine, you never have to empty a machine of a messy water/abrasive mix.

Flexible set up options allow you to position the water injector either at the base of the blast machine or at the nozzle – your choice. With the injector at the nozzle, you can adjust the water/abrasive mix at any time.

You can dry-blast with the FLEX, simply remove the injector adaptor mounted at the base of the machine, and turn off air to the pump. 

  • Skid Mounted - All-in-one convenient design with fork lift pockets and lifting eyes.
  • Water Source - On board water tank or municipal water source – add rust inhibitor if needed.
  • Abrasive Cut off Switch - With injector and ACS at the nozzle, you can control wash down and surface blow off without a trip to the blast machine.
  • No Pot Tender Needed - With the injector adaptor and ACS mounted at the nozzle, there’s no need for a pot tender.


Wetblast FLEXTM Base Unit

6 ft3  Blast Machine with Pneu Remotes and 50 ft Control Line
120 Gallon Water Tank
Wetblast InjectorTM Pump Module
Base-Mount Wetblast InjectorTM
Standard Wetblast InjectorTM with 50' Hose
Abrasive Cut-Off Switch
Blast Machine Screen & Cover
1 ½" Pressure Regulator & Air Filter 


Available Literature:
09321 - Wetblast Injector Systems

Available Videos:

 

We hope that you are able to find the information or product that you need. Please contact our office for any further information, we welcome your enquiry.



If you have any questions or comments about this web site free phone 0800 646 3725 (New Zealand) or 1800 309 734 (Australia) or go to our feedback page
Copyright 2006-2017 Industrial Minerals (NZ) Ltd